TSX562IQ2T Overview
Packaging for the buffer amplifier is in the form of a 8-WFDFN case. A General Purpose-type buffer amplifier is shown here. There is a Tape & Reel (TR) case that is delivered with the instrumentation amplifiers. A total of 8 terminations have been reported in the past few weeks. I would like you to keep in mind that this buffer amplifier needs to be run at a voltage of 3.3V. An 8-pin op amp ic is included in the package. With regards to the offset voltage of the input, buffer amplifier is rated at 1mV. For this electrical component, the recommended mounting type is Surface Mount, which is the most common. The buffer amplifier functions well at -40°C~125°C as far as operating temperature is concerned. Using a supply current of 250μA , this buffer op amp will be able to operate. Keeping the voltage gain at 85dB is the best course of action. 2 channels are available on the instrumentation amplifier. A TAPE AND REEL-shaped amplifier is used to pack the buffer amps.
TSX562IQ2T Features
supply voltage of 3.3V
85dB voltage gain

TSX562IQ2T Applications
There are a lot of STMicroelectronics
TSX562IQ2T Instrumentational OP Amps applications.

single/dual op amp sum and difference circuits
Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing

Lifecycle Status	ACTIVE (Last Updated: 6 months ago)
Factory Lead Time	18 Weeks
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	8-WFDFN
Number of Pins	8
Operating Temperature	-40°C~125°C
Packaging	Tape & Reel (TR)
Part Status	Active
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	8
ECCN Code	EAR99
Packing Method	TAPE AND REEL
Terminal Position	DUAL
Number of Functions	2
Supply Voltage	3.3V
Terminal Pitch	0.5mm
Base Part Number	TSX562
Number of Channels	2
Operating Supply Current	250μA
Nominal Supply Current	250μA
Output Current	92mA
Slew Rate	1.1V/μs
Architecture	VOLTAGE-FEEDBACK
Amplifier Type	General Purpose
Common Mode Rejection Ratio	76 dB
Current - Input Bias	1pA
Max Input Voltage	16V
Voltage - Supply, Single/Dual (±)	3V~16V
Output Current per Channel	92mA
Input Offset Voltage (Vos)	1mV
Bandwidth	900 kHz
Unity Gain BW-Nom	800 kHz
Voltage Gain	85dB
Low-Offset	NO
Frequency Compensation	YES
Low-Bias	YES
Micropower	YES
Max Frequency	10kHz
Bias Current-Max (IIB) @25C	0.0001μA
Input Voltage Noise Density	55nV/sqrt Hz
Height	750μm
Length	2mm
Width	2mm
REACH SVHC	No SVHC
Radiation Hardening	No
RoHS Status	ROHS3 Compliant
Lead Free	Lead Free